Guarantee And Support - Philips FC6232 Instrucciones De Seguridad

English
recycling
Do not throw away the appliance with the normal household waste at the
end of its life, but hand it in at an official collection point for recycling. By
doing this, you help to preserve the environment.

guarantee and support

If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet.
troubleshooting
This chapter summarises the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Problem Cause
The The appliance is not
appliance plugged in or not
does not plugged in properly.
work.
The socket is not
live or there is a
power failure.
The The filter unit or the
appliance dust container with
beeps, the the filter unit are not
vacuum assembled or not
icon flashes assembled properly.
and the red
triangle lights
up.
Solution
Make sure that you insert the plug
into the wall socket properly.
Connect another appliance to the
same socket to check if the socket
is live or connect this appliance to
another socket to check if there is
a power failure.
Make sure that you assemble the
filter unit in the dust container
and the dust container in the
appliance before you start using
the appliance.
Problem Cause
The The dust container
appliance may be full or the
suddenly filter unit may be
stops dirty. This causes the
vacuuming, motor to become
the too hot, which
appliance triggers the overheat
beeps, the protection of the
vacuum motor.
symbol
flashes and
the red
triangle lights
up.
You may have
used the vacuum
mode for more
than 30 minutes.
This triggered the
overheat protection
of the motor.
The suction The dust container is
power full, the filter is dirty
decreased or if the vacuum
suddenly. inlet is blocked.
The lamp is If you use the
not always appliance on a dark
on or goes surface, the response
on and off time of the sensor is
from time to longer.
time.
English
Solution
Unplug the appliance and empty
the dust container. Clean the filter
unit. If the appliance switches
off again when you connect it
to the mains and switch it on
again, replace the EPA filter. If this
does not solve the issue and the
appliance stops vacuuming again
and again, please contact the Philips
Consumer Care Centre.
When the motor gets overheated
because the appliance was used
longer than 30 minutes, you have
to wait 2 hours to let the appliance
cool down.
Unplug the appliance. Empty the
dust container and clean the filter.
If the vacuum inlet is dirty, use the
brush to clean it.
The UV lamp is controlled by
a sensor in the bottom of the
appliance. This sensor ensures
that the lamp goes out when the
appliance is 5cm off the surface or
the surface is very dark.