Frequently Asked Questions - Philips FC6232 Instrucciones De Seguridad

English
Problem Cause
The lamp goes on
and off as you move
the appliance over
different colours and
materials.
The mode The appliance may
indications not be plugged in
on the properly.
control
panel do not
light up.
The voltage in
your home may
not correspond to
voltage indicated on
the appliance.
The The tapping feet do
appliance not work because
beeps, the they are blocked by
tapping the fabric you are
icon flashes cleaning.
and the red
triangle lights
up.
The motor that
drives the tapping
feet may be broken.
Solution
The UV lamp is controlled by
a sensor in the bottom of the
appliance. This sensor ensures
that the lamp goes out when the
appliance is 5cm off the surface or
the surface is very dark.
Insert the plug into the wall socket
properly.
Check if the voltage in your home
is the same as the voltage indicated
on the bottom of the appliance.
Do not press the appliance into
the fabric too hard. Make sure you
apply light pressure so that the
appliance glides over the fabric
easily.
Take the appliance to your dealer
or a Philips service centre. You can
also contact the Philips Consumer
Care Centre for information.
Problem Cause
The The infrared sensors
appliance may be dirty.
beeps, the
UV icon
flashes and
the red
triangle lights
up.
The UV lamp may
be broken.

Frequently asked questions

Question Answer
If dirt and hair get No, not if you clean the prefilter and filter
trapped between the regularly. Use the cleaning brush to remove
EPA filter and the larger particles from between the folds of the
prefilter, does this EPA filter.
shorten the life of the
EPA filter?
Can I wash the EPA No, the EPA filter cannot be rinsed with tap
filter? water. Use the brush supplied to clean the
filter.
How often do I have to Replace the EPA filter every 3 to 5 months,
replace the EPA filter? depending on how often you use the
appliance. If the suction power decreases
noticeably, you have to replace the EPA filter.
Can the appliance be Yes, but only in vacuum mode. If you use it on
used on hard floors? furniture or hard floors in tapping mode, you
may damage the surface you clean.
English
Solution
Clean the infrared sensors with the
cleaning brush.
Take the appliance to your dealer
or a Philips service centre. You can
also contact the Philips Consumer
Care Centre for information.