Coolaroo Sun Shade Instrucciones De Instalación página 2

NOTE: If installing to a ceiling (fig. 4) ensure the tab on the bracket is facing towards you. If installing to a wall (fig. 5) ensure that the tab on the bracket
is facing downward. Allow at least 5.08 cm (2 in) of clearance between the bracket and wall or ceiling to allow space to snap shade onto bracket.
If brackets are installed upside down or backwards, the blind WILL NOT FIT.
Ceiling Mount
Tabs forward.
INSTALL TIE DOWNS (optional)
Tie Downs have been provided to secure your sun shade in mild to moderate wind
conditions.
a. Thread the Bungee through the End Cap Ring and back through itself making a
lark's head knot (fig. 7).
b. Install the Receiver (fig. 8) approximately 13 cm (5 in) below where the shade
will stop, to allow for proper tension of Bungee cord.
c. Attach Bungee to Receiver to secure Shade.
NOTE: Wood screws have been provided. If installing into any material other than
wood, additional screws may be needed.
Roll up your sun shade when not in use, or before strong storms, to prevent damage.
MAINTENANCE:
Your sun shade has been made of the finest materials and, when properly cared for, will provide
years of shade and privacy. To clean your shade, simply rinse with water, scrub with mild soap or any
nonabrasive cleaner, rinse and allow to dry. Call us for missing parts or mechanical problems. Do not
store shade wet. In moist areas roll shade down frequently to air dry.
CAUTION: Use of solvents or abrasive cleaners may damage the fabric and will void your warranty.
Do not use bleach or chlorine.
Questions or Comments? Contact us at:
Gale Pacific USA, Inc. | www.coolaroousa.com | 1-800-560-4667
fig. 4 fig. 5
Wall Mount
Tabs downward.
fig. 6
Register and Order
Replacement Parts Online:
www.coolaroousa.com
fig. 7
5.04.004.267