Assembly And Adjustments - DeWalt DWE305 Manual Del Usuario

EngLIsh
• Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Date Code Position (Fig. A)
The date code 6 , which also includes the year of manufacture,
is printed into the housing.
Example:
2020 XX XX
Year of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Variable speed switch
1
Blade clamp lever
2
3 Saw shoe
Intended Use
Your DWE305 reciprocating sabre saw has been designed for
professional sawing of wood, metal and plastic tubes on a
firm surface. The design permits cutting extremely close to the
edge of difficult areas. The saw blade recommendations are to
be observed.
DO nOt use under wet conditions or in the presence of
flammable liquids or gases.
Your reciprocating sabre saws are professional power tools.
DO nOt let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
18
Mounting the Saw Blade (Fig. B)
1. Move the blade clamp lever
clamping mechanism.
2. Insert the saw blade into the holder
blade can be installed with the teeth pointing down or up,
or left or right.
3. Move the blade clamp lever
clamping mechanism.
4. To remove the saw blade, proceed in reverse order.
Saw Blades
material recommended saw blade
ferrous metal fine-toothed
non ferrous metal coarse-toothed
wood coarse-toothed
plastic fine-toothed
masonry carbide-tipped
A wide variety of dedicated saw blades is available as an option.

WARNING: Always select your saw blade with great care.
OPERATION
Instructions for Use

WARNING: Always observe the safety instructions and
applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.

WARNING:
• Ensure the material to be sawn is secured in place.
• Apply only a gentle pressure to the tool and do not
exert side pressure on the saw blade. If possible, work
with the saw shoe pressed against the workpiece. This
prevents damage to the blade and stops the tool from
jerking and vibrating.
• When sawing in walls or doors be aware of the
location of pipework and wiring. Always hold the tool
by its handle.
• Avoid overloading.
• Let the blade run freely for a few seconds before
starting the cut. Never switch on the tool when the
saw blade is jammed in the workpiece or in contact
with the material.
Proper Hand Position (Fig. A, D)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
2 up to release the blade
4 until it engages. The
2 down to lock the blade