Scope Of Delivery; Warning - Cooper Tools Weller WMD 1S Instrucciones Para El Manejo

7. Scope of delivery

WMD 1A: Hot Air Station (Base Unit + Hot Air Set)
Operating Instructions
Mains Cable
WMD 1D: Desoldering Station (Base Unit + Desoldering Set)
Operating Instructions
Mains Cable
Circuit diagram see page 61
Exploded view see page 62

8. Warning

1. The mains cable is only permitted to be plugged into mains sockets or
adapters approved for the purpose.
2. Keep your workplace tidy.
Always return the soldering equipment to its original holder, when it is not needed. Do not
place any combustible objects in the vicinity of the hot soldering equipment.
3. Please observe environmental influences.
Do not use the soldering equipment in moist or wet surroundings.
4. Protect yourself against electric shock.
Prevent body contact to grounded parts, such as tubes, radiators, stoves and refrigerators.
5. Keep away from children.
Do not permit any other person to touch the tool or the cable. Keep other persons away from
your workplace.
6.Keep the soldering equipment in a safe place.
Soldering equipment, which is not required at the moment, should be kept in a dry, high
position or closed location out of the reach of children.
WMD1S 29
7. Do not overload your soldering equipment.
Operate the soldering equipment only at the voltage and pressure, respectively pressure
range mentioned.
8. Use the correct soldering equipment.
Do not use to low-capacity soldering equipment for your work. Do not use the soldering
equipment for purposes it is not intended for.
9.Wear suitable working clothes.
Danger of burn by liquid solder. Wear adequate protective clothing to protect yourself against
burns.
10. Protect your eyes.
Wear protective goggles. Observe especially the warning notes of the adhesives' manufacturer,
when adhesives are processed. Protect yourself against tin splashes. Danger of burn by
liquid solder.
11. Use a solder smoke suction device.
If facilities for the operation of a solder smoke suction device are available, please check
yourself that they have been connected and are operated correctly.
12. Do not use the cable for purposes it is not intended for.
Never carry the soldering equipment on its cable. Do not use the cable to pull the plug out of
the wall outlet. Protect the cable against heat, oil, and sharp edges.
13. Secure the workpiece.
Use a clamping device to secure the workpiece. With this device the workpiece is held down
more safely than with the hand, and moreover you have both hands free to operate the
soldering equipment.
14. Avoid unnatural posture.
Arrange your workplace in a correct ergonomic way. Avoid uncomfortable posture when
working. Always use appropriate soldering equipment.
15. Treat your soldering equipment with care.
Keep the soldering equipment clean in order to be able to work better and more safely.
Observe the maintenance instructions and the notes on the change of the soldering tip.
04.04.2002, 10:09 Uhr
29