Chapter 6: Installing The 24Cm Radiator - EVGA HADRON HYDRO Manual De Instrucciones

STEP 3
STEP 4
▪ Screw the bolt bases onto the
2
screws until the Water-block is tightly
locked in.
STEP 5
▪ To insert the tubes though the tube
connector, then using the clamp (bolt)
to fixed the tubes on the tube
connector of the water-block.
▪ The tube adapter thread of the
water-block is G 1/4", our customers
can change the tube adapter to other
thread.
▪ To install and lock the tube adapter of
the water-block entirely, and to avoid
the leak by angle wrench .
11
10
AMD Installation
Chapter 6: Installing the 240mm Radiator
1. At the rear of the Hadron you will see a mounting bracket with 2 large holes in it and it is
screwed down to the chassis and the mesh chassis cover. Please remove those 4 screws. Once
done the bracket should slide out.
2. Push the cover towards the front of the chassis approximately a half inch, from there lift the
cover straight up and it should detach.
3. Looking down at the top of the Hadron, between the fan
cutouts, there should be 2 parallel holes which are threaded,
thread in alignment bolts, and hand tighten until flush with
the case. There is also a secondary pair of standoff holes,
still adjacent to the fan cut out, towards the rear of the case.
English English
▪ To remove the Intel locker, and then
to install the AMD locker
10
4pcs screws.
▪ Following the step
~ to
1 5
finish the installation of the
water-block.
11
by the