Presetting Radio Stations; Auto Presetting Radio Stations; Fm & Fm-Stereo Reception; Fm & Fm-Stereo Radio Encoding - JVC RD-F327B Manual De Instrucciones

the knob.

The unit will start auto scanning and stop when a radio station is found.

PRESETTING RADIO STATIONS

Up to 30 FM and 20 AM radio stations can be preset.
1. When the desired radio station is found, press
The program number will flash.
2. Press
station.
3. Press to confirm.
The program number will stop flashing.
4. Repeat steps 2 & 3 until all desired radio stations are stored.
5. Press

AUTO PRESETTING RADIO STATIONS

Press , the unit will automatically scan the radio frequency. When the clear signal is found, the unit will
automatically store the radio station, starting from program number 1.
FM & FM-STEREO RECEPTION
Press on the remote control to select FM mono or FM stereo mode. When stereo signals are weak, the unit will receive
the radio stations in mono mode.
"ST" icon will be displayed when the station is broadcasting in stereo.
HINTS FOR BETTER RECEPTION
AM: There is a built-in am bar antenna. If the reception is weak, slightly rotate or re-position the unit.
FM: Fully extend the FM wire antenna for best reception and tape its tip to a wall or other surface.
FM & FM-STEREO RADIO ENCODING
1. Press
band (AM or FM).
2. Insert a memory device.
3. Press and the unit will take 3-5 seconds to read memory device.
4. Turn
confirm.

The system will start the encoding process after a few seconds.
5. To finish encoding, press
REMARK:
- The recording speed is 1:1 and based on the actual playing time of FM or FM-stereo radio.
- The recording format is preset at 128 kbps.
- During FM & FM-stereo radio encoding, radio frequency will be fixed and cannot be tuned.
PHONO & ENCODING
NOTES:
Remove the stylus protector.
-
Be sure that the tone arm is detached from the tone arm rest before operating and re-
-
secured again afterwards.
1. Repeatedly press
2. Set the speed selector to the proper position depending on the record to be played.
/
/
to activate the radio mode and then press
knob to select desired mode (USB or SD) for encoding. Then press
and the unit will return to the radio mode and the track is recorded in the "LINE-IN" folder.
on the remote until the display shows "PHON".
EN-6
.
to choose the program number for storing the desired radio
to choose the preset radio stations.
again to select the desired
Stylus assembly
to
Cartridge