Module Installation - Lowara 001084018 Manual De Instalación, Uso Y Mantenimiento

4 Installation
Precautions
WARNING:
• Observe accident prevention regulations in force.
• Use suitable equipment and protection.
• Always refer to the local and/or national regulations, legislation,
and codes in force regarding the selection of the installation site and power
connections.
Electrical Hazard:
• Make sure that all connections are performed by qualified installation
technicians and in compliance with the regulations in force.
• Before starting work on the unit, make sure that the unit and the control panel
are isolated from the power supply and cannot be energized.
4.1

Module installation

Figure 1 and 2
See
1. Power off the pump.
2. Open the terminal box of the pump head ❶ removing the cover ❷.
3. Plug the flat cable of the module on the connector of the terminal box.
4. Fix the module using the clips
5. When the module is connected, the secondary RS-485 channel become available. If
necessary connect the communication cable to terminals 18 – 19 – 20 of the pump.
6. Close the pump head terminal box.
7. Power on the pump again.
For wireless module use see section 5 of this manual
5 Wireless module use
When the wireless module is assembled into ecocirc XLplus, and correctly configured (see
the ecocircXL installation manual), it generates a wireless network accessible (by a
mobile, tablet or a PC) using data (S/N and PWD) printed on the label sticked on the side
of the circulator's drive.
In particular,
Network name: "xylemecoxl___S/N___" where S/N is a 8 character word
Password: "xylem___PWD___" where PWD is a 8 character word
To access then the circulator's web pages using a browser (on the external device
connected), use the web address "https://xylemecoxl" or type directly "192.168.1.10"
as reference.
en - Translation of original instructions
11