Pre-Installation Requirements; For A Telecom Rack; For A Server Rack; Installation In A Telecom Rack - Dell PowerConnect W-650 Guia De Instalacion

Pre-Installation Requirements

The following tools and equipment are required for installation of a W-650 Series controller.
Rack Mount Bracket (x2, not used for tabletop installation)
Suitable Screwdrivers
AC Power Cord (country-specific)
Left and right side bezels (not used for rack mounting)
Warning: Before performing the following procedure, review the safety instructions that came with the controller.

For a Telecom Rack:

M3, 6mm x 0.5mm Phillips Head Screws (6x, included)
12-24 x 5/8" Phillips Head Screws (4x, included)

For a Server Rack:

M3, 6mm x 0.5mm Phillips Head Screws (6x, included)
M6 x 20mm Phillips Head Screws (4x, included)
M6 Cage Nuts (4x, included) or M6 Cage Clips (4x, included)

Installation in a Telecom Rack

To install a W-650 Series controller into a 19-inch (48.26 cm) Telecom rack system:
1. Place a rack mount bracket over the mounting holes on one side of the controller (see
2. Secure the bracket to the controller using three M3, 6mm x 0.5mm phillips head screws and a screwdriver.
3. Repeat these steps on the opposite side of the controller.
Dell PowerConnect W-650 Controller | Installation Guide
Chapter 2
W-650 Series Installation
Figure
W-650 Series Installation |
6).
13