Transmit Power
Configurable in increments of 0.5 dBm
Association Rates (Mbps)
802.11b: 11, 5.5, 2, 1 with automatic fallback
802.11a/g: 54, 48, 36, 24, 18, 12, 9, 6 with automatic fallback
802.11n: MCS0 - MCS15 (6.5Mbps - 300Mbps)
802.11n High-Throughput (HT) Support
HT 20
HT 40
802.11n Packet Aggregation
A-MPDU
A-MSDU
Antenna (W-651 Internal AP)
Three RP-SMA interfaces for external antenna support (supports up to 3x3 MIMO with spatial diversity)
Three AP-ANT-1B omni-directional dual-band antennas included
Safety and Regulatory Compliance
Dell provides a multi-language document containing country specific restrictions and additional safety and
regulatory information for all Dell hardware products. The Dell PowerConnect W-Series Safety, Environmental,
and Regulatory Information document is included with this product.
Caution: Use of controls or adjustments of performance or procedures other than those specified in this manual may result in
hazardous radiation exposure.
This product complies with 21 CFR Chapter 1, Subchapter J, Part 1040.10, and IEC 60825-1: 1993, A1: 1997, A2:
2001, IEC 60825-2: 2000.
For continued compliance with the above laser safety standards, only approved Class 1 modules from our
approved vendors should be installed in Dell products.
FCC Class B Device
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
18
| Specifications, Safety, and Compliance
CLASS 1
LASER PRODUCT
Dell PowerConnect W-650 Controller | Installation Guide