Installation In A Server Rack - Dell PowerConnect W-650 Guia De Instalacion

Figure 8
Keep Clear for
Air Exhaust
7. Connect the AC power cord (country-specific) to the rear of the unit.
8. Plug the opposite end of the power cord into an electrical outlet to power the controller.
Note: W-650 Series controller does not have a switch for turning power to the unit on or off. Power to the unit is controlled by
connecting or disconnecting the plug on the power cord to or from an electrical outlet.

Installation in a Server Rack

To install a W-650 Series controller into a 19-inch (48.26 cm) Server rack system:
Note: The following instructions describe the installation of your controller in a rack with unthreaded, square holes. For a rack
with unthreaded, round holes, use the provided clip nuts instead.
1. Place a rack mount bracket over the mounting holes on one side of the controller (see
2. Secure the bracket to the controller using three M3, 6mm x 0.5mm phillips head screws and a suitable
screwdriver.
3. Repeat these steps on the opposite side of the controller.
4. Install the four cage nuts.
To install the cage nut with a cage-nut installation tool:
a. Begin by inserting the lower lip of the cage nut over the bottom of the square opening in the back of the
rail.
b. Insert the small end of the cage-nut installation tool through the opening in the rail (from the front), and
hook the tool over the top lip of the cage nut.
c. Push the cage nut in towards the rail while rotating the tool up and pulling the tool back toward you until
the top lip of the cage nut snaps into position.
To install the cage nut with a flathead screwdriver:
Dell PowerConnect W-650 Controller | Installation Guide
Air Flow Requirements
Keep Open for
Easy Access
Keep Clear for
Air Intake
Keep Open for
Easy Access
W-650 Series Installation |
Figure 6).
15