Kenwood multione KHH30 Manual De Instrucciones página 11

The processing of spices is not recommended as they may
l
damage the plastic parts.
The appliance will not work if the compact chopper/grinder is
l
incorrectly fitted.
Use dry ingredients only.
l
before plugging in
Make sure your electricity supply is the same as
l
the one shown on the underside of your appliance.
This appliance conforms to EC Regulation
l
1935/2004 on materials and articles intended to
come into contact with food.
before using for the first time
Wash the parts: see 'care and cleaning'.
l
key
outlet cover
1
dual drive outlet (medium and high speed)
2
interlocks
3
4 cord storage compartment
speed/pulse control
5
6 power unit
bowl tool socket
7
8 bowl
mixer head
9
head release lever
bk
K-beater
bl
whisk
bm
spiral dough hook
bn
creaming beater (if supplied)
bo
splashguard
bp
attachments
Not all of the attachments listed will
necessarily be included with your
kitchen machine. Attachments are
dependent upon the model variant.
food processor (if supplied)
bq
citrus juicer (if supplied)
br
bs glass blender (if supplied)
juice extractor (if supplied)
bt
ck food mincer (if supplied)
pasta maker (accessory for food mincer) (if
cl
supplied)
compact chopper/grinder (if supplied)
cm
Refer to the recommended speed chart for each
attachment.
the mixing tools and some of
their uses
K-beater
bl
For making cakes, biscuits, pastry, icing, fillings,
l
éclairs and mashed potato.
bm whisk
For eggs, cream, batters, fatless sponges,
l
meringues, cheesecakes, mousses, soufflés.
Do not use the whisk for heavy mixtures (e.g.
creaming fat and sugar) - you could damage it.
spiral dough hook
bn
For yeast mixtures.
l
creaming beater (if supplied)
bo
The creaming beater is designed for creaming and
l
mixing soft ingredients. Do not use with heavy
recipes such as dough or hard ingredients, for
example those containing fruit stones, bones or
shells.
Fitting the wiper blade
The wiper blade is supplied already fitted and
l
should always be removed for cleaning
1 Carefully fit the flexible wiper blade onto the tool
by locating the base of the wiper blade into the
slot then fit one side into the groove before
5
gently hooking the end in place
the other side
7
Checking the beater height
The beater height has been set in the factory and
l
should not require adjusting. If height adjustment is
required follow the procedure below.
1 With the mixer switched off, insert the creaming
beater and lower the mixer head.
Check the position of the beater in the bowl
Ideally it should be in contact with the bowl surface
so that it gently wipes the bowl during mixing.
2 If the clearance needs to be adjusted, raise the
mixer head and remove the beater.
3 To loosen and allow adjustment of the shaft
rotate the nut clockwise using a 15mm spanner
(not supplied in pack).
To lower the beater closer to the bottom of the
l
bowl, turn the beater shaft clockwise.
6
. Repeat with
6
.
.
bk
.
8
,
9