MIRKA DEROS 325CV Manual De Instrucciones página 66

en (original)
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to an App from which additional
tool functionality can be accessed. For more information on the App functionality and if it is available in your country, go
to www.mirka.com.
Activate Bluetooth on your Mirka
Connect the power cord to mains outlet.
1.
2. Press and hold the rpm+ button while switching the tool on with the On/Off button.
3. Left LED lights up (green), to indicate that Bluetooth is active.
Bluetooth is deactivated when the tool is disconnected from mains outlet.
4.
NOTE! If the App is not installed or if it is not available in your country, Bluetooth shall not be activated.
®
The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
Reducing vibration when sanding with pad saver or interface
When pad saver or interface is used for sanding, this set-up may increase the level of vibration. Your Mirka tool has a
feature that allowing to reduce this vibration. To reduce vibration that may occur when a pad saver or interface is used,
please follow these steps:
Disconnect power cable.
1.
2. Remove backing pad.
3. Add hex nuts and screws in accordance with the table below, tighten to 2 Nm.
Note! If the sander is used with an interface it is recommended that the speed is set to a maximum of 7,000 rpm.
Example
1. Machine configuration out of box.
3. Machine configuration out of box.
Model
66
® DEROS as follows:
2. Machine configuration for use with pad saver or interface.
4. Machine configuration for use with pad saver or interface.
Picture
A B
Set-up out of box
Screw
C D E A
Hex nut
B C D E