MIRKA DEROS 325CV Manual De Instrucciones página 68

en (original)
Model
DEROS 550CV/NV
DEROS 625CV/NV
DEROS 650CV/NV
DEROS 680CV/NV
DEROS 5650CV/NV
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad
Insert the pad wrench between the backing pad and brake seal to hold the spindle nut.
1.
2. Turn the backing pad counterclockwise to remove it.
3. Fit and tighten the new backing pad with washers.
Remove the pad wrench.
4.
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and continuously
with net products. These cost effective pad savers, placed between the backing pad and the sanding disc, should be
changed regularly. The pad savers prolong the life of the backing pad.
https://www.mirka.com/accessories/pad-savers/
Replacing the brake seal
NOTE! Too much vacuum in your dust extraction system may cause the brake seal to malfunction.
1. Remove the backing pad as described above.
Pull the old brake seal out of its groove.
2.
Fit the new brake seal in the groove.
3.
4. Fit the backing pad as described above.
5. Check the brake seal function. By changing the number of washers between the spindle and backing pad, the
effect of the brake seal can be adjusted.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service or your Mirka dealer.
68
Picture
6 -
6 -
6 -
7 X
6 -
Set-up for padsaver/interface
- X
- X
- X
X X X
- X
- - X
- - X
- - X
X X
- - X