Mhouse RT3N Instrucciones Y Advertencias Para La Instalación Y El Uso página 13

Programming the working time
The "Working Time" is the time during which the RC1 receiver commands
the motor for the "Ascent" s and "Descent" t manoeuvres, and both the
factory time and the time after the memory has been deleted are approxi-
mately 150 seconds. If necessary, the running time can be altered from a
minimum of 4 seconds to a maximum of 250. The programming procedure
is carried out in the "self-recognition" state, or better, by measuring the time
necessary to carry out the entire manoeuvre. The motor must be moved and
set next to a limit switch and the most difficult (and therefore slowest) ma-
noeuvre for the motor measured. This is normally re-winding. The manufac-
turer recommends that users programme a working time which is a few
seconds longer than the time which is strictly necessary for the manoeuvre.
Moreover, considering that the manoeuvre in which the measurements are
taken begins in the opposite direction to the last manoeuvre carried out, be-
fore starting programming it is worth moving the motor to the limit switch
position of the least difficult manoeuvre.
A transmitter memorised in Mode I is necessary for programming, then follow
the steps described in the table below.
Table [G] Programming the working time
Press and hold down key n of a
1
previously memorized transmitter until
you hear a beep (after about 5 seconds)
then release it
Press again key n until you hear 4 short
2
beeps (after approx. 5 seconds), then
release
Press s key (or t key) in order to begin
3
the manoeuvre and start up the time
counting phase
Example
5s
5s
English – 11