Mhouse RT3N Instrucciones Y Advertencias Para La Instalación Y El Uso página 6

MEMORIZATION OF RADIO TRANSMITTERS
A memorization procedure must be executed in order to enable the STX1
transmitter to control the RC1 receiver. Besides the STX1 transmitter, which
is specifically designed to use in automations for awnings and rolling-shut-
ters, it is also possible to memorise the GTX4 transmitters which are nor-
mally used in automations for
WARNING:
• All the memorisation sequences described in this chapter are timed, that
is, they must be completed within the programmed time limits.
• Programming via radio may be done on all the receivers within the range
of the transmitter; therefore, only the one involved in the operation should
be kept switched on.
You can check whether any transmitters have been previously memorized in
the receiver; this is done by counting the number of beeps emitted when
the receiver is switched on.
Checking the memorized transmitters
3 short beeps
2 long beeps
Two different procedures can be followed to memorize the transmitters:
– Mode I: simplified memorization (the transmitter keys are automatically
configured by the RC1 receiver).
– Mode II: advanced memorization (each single transmitter key can be
configured for a specific command).
4 – English
— STEP 5 —
There are previously memorized transmitters
No memorized transmitters