Additional Information - Mhouse RT3N Instrucciones Y Advertencias Para La Instalación Y El Uso

Even if one or more transmitters have already been memorized in Mode I,
additional transmitters can be memorized in Mode I, as described in Table [B].
Table [B] Memorizing additional transmitters
in Mode I
Press and hold down key n of the new
1
transmitter to be memorized (New TX)
until you hear a beep (after about 5
seconds) then release i
Press key n of a previously memorized
2
transmitter (old TX) slowly 3 times
3 Once again, press and release the key on
the new transmitter you pressed
according to step 1
The 3 final beeps signal that the new transmitter has been correctly memorized.
If the memory is full (30 transmitters), 6 beeps will signal that the memory is not
capable of memorizing any additional transmitters.
This chapter examines the various memorisation possibilities of the RC1
receiver 1.
Memorization in Mode II (advanced memorization)
In this mode, one of the 4 available commands can be associated to each
transmitter key, as shown in Table [C].
In this mode, the memorization procedure is performed separately for each
single transmitter key; this means that 2 keys on the same transmitter can be
6 – English

ADDITIONAL INFORMATION

— STEP 6 —
Example
New TX
Old TX
New TX