BUCK COMMANDER AGC-408 Manual De Instrucciones página 2

SHELF ASSEMBLY
e top shelf has 2 sets of holes for a aching the center partition. Use the
right set of holes as shown. Position the shelf so the front and side anges
point down. Assemble the top shelf to the center partition and the sides of
the cabinet using 6 nuts and bolts.
BARREL REST INSTALLATION
INSTALL THE BARREL RESTS BEFORE MOUNTING THE CABINET
TO A WALL AND FLOOR.
Assemble the barrel rest to the back and right side of the cabinet with 2 screws
each as shown.
read the screws into the pilot holes from the outside of the cabinet. Align
the holes of the barrel rest over the tips of the screws and lightly press the
barrel rest into place. Now tighten the screws from the outside of the cabinet.
Tighten each screw partially, alternating from one screw to the other until
they are both tight. Do not over tighten.
FOAM INSTALLATION
Your foam kit will cover the inside walls of the le side of the cabinet. Install
the foam from the bo om up.
covered by a removable backing. Before removing the backing, place the foam
in the cabinet as described below to make sure you are using the correct size
foam for each step. For best results, remove the backing by pinching the
backing and the foam together at a corner and then peeling away the backing.
1. Cabinet Side Foam (2)
Start at the bo om of the cabinet. Remove
the foam backing and gage the foam to the
inside bo om and back of the cabinet.
Apply the upper foam panel by gaging the
upper side foam to the top of bo om side
foam and to the back of the cabinet.
2. Cabinet Back Foam (2)
Start with the bo om cabinet back foam.
Remove the foam backing and gage the foam
to the inside bo om of the cabinet and to the
lower side foam. Gage the upper back foam
to the top of the bo om back foam and to
the upper side foam.
3. Cabinet Partition Foam (2)
Start with the bo om cabinet partition foam.
Remove the foam backing and gage the foam
to the inside bo om of the cabinet and to the
lower back foam. Gage the upper partition
foam to the top of bo om partition foam and
to the upper back foam.
Place the 2 bo om pads and shelf pad in the
cabinet as shown.
have adhesive backing.
e foam panels have an adhesive coating that is
16 1/2"
[419mm]
22"
[559mm]
10 1/4"
[260mm]
22"
[559mm]
11 1/2"
[292mm]
22"
[559mm]
ese foam pads do not
40305-1401
2
21