Multimetrix CM600 Manual De Instrucciones página 12

 Never touch any metal part of the contact points with your
finger.
 Check the mechanical and electrical condition of the power
cables and
measurements. Any power cables or contact points that are
damaged must be replaced immediately. Never use the
instrument if it is damaged.
 Never work with the instrument's rear casing open.
 Never change the batteries while the power cables are
connected.
 Do not use the instrument in, or expose it to, direct sunlight,
high temperatures or high levels of humidity.
 Never alter the internal electronic circuits.
 Do not remove the casing; only the battery compartment
cover may be opened.
 Never alter the internal electronic circuits.
1.5 OTHER SAFETY RECOMMENDATIONS
 For instruments of installation categories I and II, never work
on equipment that could generate voltage spikes (motors,
etc.).
 When measuring in the manual range, always start with the
maximum range and then select the most appropriate range.
 First of all connect the black contact point and then the red
one.
 Disconnect the power cables before changing function.
 First of all disconnect the red contact point and then the
black one.
 Use and install batteries that comply with the instructions in
the user's manual for the product you have purchased.
 Check that there is no voltage present before using the
and Ω functions.
The instrument is guaranteed against any material or
manufacturing fault in accordance with the General Sales
Conditions. During the guarantee period, the instrument may
only be repaired by the manufacturer, who reserves the right
either to proceed to repair the product or replace it in whole or
in part. If any equipment is returned to the manufacturer, the
customer is responsible for paying the outward transport costs.
The guarantee does not apply in the case of:
 Improper use of the instrument or its use with incompatible
equipment.
 Modification of the instrument without express authorisation
from the manufacturer's technical departments.
 Any work being performed on the instrument by anyone not
formally approved by the manufacturer.
 Any adaptation for any particular application not provided for
in the instrument's definition or the operating instructions.
 An impact, a fall or drenching in water.
 Information and contact details for our After-Sales Services:
contact your distributor.
3. UNPACKING AND REPACKING
All the equipment has been checked mechanically and
electrically before dispatch.
However, you are advised quickly to check for any damage
during transport. Should this be the case, inform the freight
forwarder immediately of your reservations.
If you are sending anything back, please use the original
packaging and attach a note indicating the reason for the
return.
the contact
2. GUARANTEE
11
points before taking any