Multimetrix CM600 Manual De Instrucciones página 17

8. TO REPLACE THE BATTERIES
Please read the safety recommendations before use.
There must be no voltage in the circuit.
The batteries must be replaced when the
displayed:
1. Disconnect the contact points.
2. Set the commutator to OFF.
3. Remove
compartment cover. Replace both the 1.5V AAA / LR3
batteries, paying careful attention to the polarities.
4. Replace the cover and fasten the screws.
NB: Remove the batteries if the multimeter will not be
used for a prolonged time.
the fixing screws and
16
icon (17) is
the battery