Continuity Test - Multimetrix CM600 Manual De Instrucciones

CM600 & CM610: 200 Ω or 20 MΩ (6 ranges)
-
CM625: 400 Ω or 40 MΩ (6 ranges)
-
1. CM600 & CM610: set the selector (3) to
CM625: set the selector (3) to
2. Insert the black connector into the COM terminal (1),
the red connector into the + terminal (10) and take the
voltage reading.
If OL is displayed, the capacity has been exceeded.
3. Set the selector to OFF.
7.7 DIODE TEST (CM600 & CM610)
Please read the safety recommendations before use.
There must be no voltage in the circuit.
1. Set the commutator to
2. Proceed to test directly.
Connect the black contact to the cathode and the red
contact to the anode. The measurement is 0.5 to 0.7V for
a silicon diode and 0.2 to 0.3V for a germanium diode. A
value close to zero indicates a short-circuit. OL indicates a
diode has shorted out.
3. Proceed to test in reverse.
Connect the black contact to the anode and the red
contact to the cathode. A correct diode will show OL. The
diode is defective if a voltage is displayed.
4. Set the selector to OFF.

7.8 CONTINUITY TEST

Please read the safety recommendations before use.
There must be no voltage in the circuit.
1. CM600 & CM610: Set the selector (3) to
press SELECT to display
CM625: Set the selector (3) to
to display
2. Insert the black cable in the COM terminal (1), the red
cable in the + terminal (10) and apply the contact
points to the circuit to be checked.
The buzzer sounds when the circuit to be checked is DC
or has a resistance of less than 90 Ω ± 40 Ω (CM600 &
CM610) or 50 Ω ± 25 Ω (CM625).
3. Set the selector to OFF.
7.9 MAX FUNCTION (DISPLAYS MAX. VALUE – (CM600 &
CM610)
1. Set the selector to
The
2. Take the measurement.
The maximum
automatically.
3. Press MAX to deactivate the
7.10 HOLD FUNCTION (STORES THE READING IN MEMORY -
CM625)
1. Apply the contact points to the circuit to be checked.
The maximum
automatically.
2. Press the HOLD button during the measurement.
The
measurement is stored.
The automatic shutdown function is deactivated.
3. To deactivate the
(13).
icon appears (18).
measurement
measurement
(Data Hold)
.
.
(13).
and press SELECT
or
will
function.
will
icon (24) appears
function, press HOLD.
15
.
and press MAX.
be updated
be updated
and
and
the