Drill A Hole In The Wall; Installation Of Wired Remote Controller - LG A2UW18GFAB Manual De Instrucciones

INSTALLATION OF WIRED REMOTE CONTROLLER

12

Drill a hole in the wall

Drill the piping hole with a Ø65mm hole core drill. Drill the piping hole at either the right or the
left with the hole slightly slanted to the outdoor side.
INSTALLATION OF WIRED REMOTE CON-
TROLLER
1
Please fix tightly using provided screw after placing remote controller setup board on the
place where you like to setup.
- Please set it up not to bend because poor setup could take place if setup board bends.
Please set up remote controller board fit to the reclamation box if there is a reclamation box.
2
Can set up Wired remote controller cable into three directions.
- Setup direction: the surface of wall reclamation, upper, right
- If setting up remote controller cable into upper and right side, please set up after removing
remote controller cable guide groove.
h Remove guide groove with long nose.
① Reclamation to the surface of the wall
② Upper part guide groove
③ Right part guide groove
WALL
Indoor Outdoor
2
3
1
<Wire guide grooves>
2
3