BGS technic 8841 Manual Del Usuario página 20

Cabinet
Note: All gaskets are pre-fitted on all needed plates. Use a punch or nail to make holes in the Foam
Gasket for bolt installation.
TOP TIP:
Place the top plate on a table edge with the gaskets facing up.
Note: Align the three middle holes along the Top Plate (16) first, then align the remaining holes when
assembling. Leave all connections loose until all bolts are in place. Use the Flange Bolts (47), Flat
Washers and Nuts to secure the sections in place.
1. Attach the Front Cabinet Plate (17), and the Back Cabinet Plate (19) to the top edges of the top
plate (16) overlapping the front and back flanges over the edges of the top plate (16). (See
Detail 1 on page 10)
2. Place the Left Cabinet Plate (18) over the edges of the Front and Back Cabinet Plates and the
Top Plate.
3. Place the Door Frame to the other side of the Front and Back Cabinet Plates and Top plate and
secure with bolts (47), nuts and flat washers. Align the holes of the Door Hinge and Door (24/13)
along the back edge of the Cabinet Back Plate (19) and secure in place with bolts and nuts pre-
assembled on door and hinge assembly.
4. After all panels are in place, tighten all connections.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
5
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed