Operation - cecotec Conga 990 Vital Manual De Instrucciones

ENGLISH
objects.
Fig. 17.
If there is a balcony or staircase in the area to be cleaned, a physical barrier must be placed in
order to prevent product damage and ensure safe operation.
Fig. 18.
Fig. 19.
Direct exposure to sun light or great light contrasts may affect to the correct operating of the
sensors. If this happens and the robot stops, change it to a new location for it to start operating
again.
Fig. 20.
Connect the charging base to a power supply. Wind and store the remaining cord in the lower
part of the charging base to avoid accidents.
Fig. 21.
Place the charging base against the wall and leave a minimum free space of:
2 metres to the front.
1 metre to each side.
Fig. 22.
Install both side brushes in their corresponding slots, located on the robot's bottom part. Press
until it clicks to make sure they are properly fixed.
Fig. 23.
Press the power switch located on the bottom part of the robot. Make sure the power switch
in ON.
Fig. 24.
Place the robot on the charging base and make sure the charging terminals on the robot match
with those of the charging base. Once the robot is properly placed, it will beep once and the
button will light up. If the light blinks orange, it means the battery is not completely charged. To
ensure maximum cleaning time, wait until the light switches to steady blue. This will indicate
the battery is fully charged and that the robot is ready to clean.

4. OPERATION

Fig. 25.
Start cleaning
Long press the power button on the robot to activate the robot.
Press the power button on the robot or on the remote control to start cleaning.
CONGA 990 VITAL
28
Note: If the robot runs out of battery during cleaning, it will automatically return to the charging
base. Once the battery is fully charged, the robot can start a new cleaning cycle.
Warning: If there is no good access to the charging base, the robot will not be able to return to
its charging position. In that case, once the robot has stopped, take it manually to the charging
base.
Pause
Press the power button on the robot or on the remote control to pause the cleaning process.
Press the power button on the robot or on the remote control to resume the cleaning process.
Return to the charging base
Fig. 26.
Press the back home button on the remote control in order to send the robot to the charging
base.
Turn off
Long press the power button to turn the robot off.
Warning: The robot vacuum cleaner has a power switch located on its main body. If the robot
is not going to be used for long periods of time, it is suggested to switch it off. If the robot is
switched off, it will restore factory default settings as a safety measure. The robot will only
carry out scheduled cleaning if it has been scheduled while the switch is ON, otherwise, it will
have to be scheduled again from the remote control.
Cleaning modes
This robot includes different modes and different functions that can be activated from the
remote control.
Auto mode
Fig. 27.
Press the power button for the robot to start Auto cleaning mode.
The robot will clean the whole surface, edges, around objects such as tables, chairs etc. Once
it starts running out of battery, it will return to the charging base.
Scrubbing mode
Fig. 28.
Attach the mop cloth to the Wet & dry tank and fill the tank with water.
Install the Wet & dry tank in the robot and turn it on.
Use the remote control to select the desired scrubbing power level: High, Medium or Low.
ENGLISH
CONGA 990 VITAL
29