VICAIR ACTIVE O2 Manual Del Usuario página 7

Caution! Do not use aggressive or abrasive
cleaners, or sharp objects to clean the cushion.
Caution! Remove foam inlay before washing this
cushion in a washing machine.
Caution! Do not use the foam inlay without the
foam inlay liner.
Caution! Do not place the topside of the Vicair
O2 cushion against the glass of the washer door.
Cleaning the Vicair Active O2
After you have emptied the storage pouch and
removed the foam inlay, your Vicair Active O2
cushion can be machine washed at 60°C / 140 °F
using an anti-crease cycle and mild detergent.
You do not need to remove the SmartCell liners
before putting the cushion into the washing
machine. Make sure the topside of the cushion
is not placed against the glass of the washer
door. Do not load the machine with more than
half of its maximum load weight. Spin speed
should be reduced. When using a machine with
agitator, make sure that the cushion can move
freely within the drum. Do not use any chlorine
bleach and do not dry clean! Do not tumble dry
your Vicair Active O2 cushion but let it air dry
(5-6 hours).
0 2 3 7 9
Cleaning the Vicair Active O2 foam inlay
Do not machine wash the foam inlay and do not
immerse it in water or any other liquid. To clean
the foam inlay you first remove it from its
compartment.
• Cleaning the foam inlay liner
Take the foam out of the foam inlay liner.
The emptied liner can be machine washed at
60°C. Follow the washing instructions on the
label attached to the inside of the liner.
1 2 3 4 5
•
Cleaning the foam
Take the foam out of the foam inlay liner and
clean it by using a disinfectant spray.
6 7 8
Disinfecting your Vicair Active O2
Warning! In case of soiling with body fluids, and
when transferring the product to another user,
the product must be disinfected to avoid cross
contamination. Clean the Active O2 cover, foam
inlay and SmartCell liners as instructed above.
Preferably use an anti-bacterial detergent. After
cleaning spray your cover, foam inlay liner and
SmartCell liners with a disinfectant. Bend the
cover compartments outwards to make sure the
spray gets into the gaps.
(Re)assembling your Vicair Active O2
The Vicair Active O2 is fully assembled on
delivery. When it needs to be (re)assembled, for
instance after cleaning, follow the assembly
instructions underneath. The instructions
correspond to image i (I, II & III) on the Quick
Installation Guide.
Placing the foam inlay in the Vicair Active O2
cover (image i - I)
Caution! Do not use the foam inlay without the
foam inlay liner.
• Completely open the zipper at the front of
the Active O2 cover.
• Place the foam inlay in the Active O2 cover,
the sloping side pointing to the back of the
cushion and the contoured side on top.
• Close the zipper. Make sure you do not
damage the foam inlay liner.
Adjusting the number of SmartCells in the
SmartCell liners (image i - II)
Warning! Vicair B.V. recommends to adjust the
filling grade under the direct supervision of your
therapist or technical advisor.
E N
7