Dash Disassembly; Honda Fit 2009-2013 - Metra 99-7877 Instrucciones De Instalación

1. Unclip and remove the lower
center panel below radio.
(Figure A)
2. Remove (1) 8 mm bolt facing up
behind center panel.
Note: Slide the recirculation
control lever to FRESH for better
access to bolt. (Figure A)
3. Open the upper glove box then use
a pry tool to unclip and remove the
radio/climate control assembly.
(Figure B & C)
(Figure A)

Dash Disassembly

(Figure B)
(Figure C)
99-7877
4. Remove (2) Phillips screws
securing the hazard switch
to the back of the factory
radio panel. (Figure D)
5. Remove (2) Phillips screws
securing the air bag light to
the back of the factory radio
panel. (Figure E)
6. Remove (5) Phillips screws
securing the A/C vents to
the radio panel.
7. Remove (7) retaining clips
from radio housing to be
used later in kit preparation.
Continue to kit preparation
2
Rear factory radio panel
(Figure D)
Rear factory radio panel
(Figure E)