Setup Menu; Printer Set-Up - Uline H-5819 Manual Del Usuario

ENABLE ACCUMULATION
At startup, the accumulation mode is enabled. Enter this
menu to turn the accumulation mode on or off.
1. Turn on the scale and press the TARE key
PO CAL
the self-test.
PO CAL
Tare
2. Press the TARE key
display.
3. Press the ZERO key
ACC
4. will be shown on the display. Press the TARE key
to select on or off. Press the ZERO key
the new setting.
Tare
5. Press the TARE key
press the MODE key
ENABLE AUTOMATIC ACCUMULATION
At startup, the automatic accumulation mode is
not enabled. Enter this menu to turn the automatic
accumulation mode on or off.
1. Turn on the scale and press the TARE key
PO CAL
the self-test.
PO CAL
2. Press the TARE key
display.
3. Press the ZERO key
4. Press the TARE key
• AU on – Automatic Accumulation is on.
• AUoFF – Automatic Accumulation is off.
• P Cont – Continuously send data to PC.
• ASF – Send current data to printer.
5. Press the ZERO key
Tare
6. Press the TARE key
press the MODE key
PAGE 9 OF 33
Tare
will be shown on the display.
P4 ACC
until is shown on the
Zero
to enter the menu.
Zero
to view additional menus or
to exit the setup menu.
Mode
Tare
will be shown on the display.
P5 Ato
until is shown on the
Tare
Zero
to enter the menu.
to change the setting.
Tare
Zero
to select the new setting.
to view additional menus or
to exit the setup menu.
Mode

SETUP MENU

PRINTER SET-UP

Enter this menu to select a printer.
1. Turn on the scale and press the TARE key
the self-test.
during
PO CAL
2. Press the TARE key
display.
3. Press the ZERO key
4. Press the TARE key
• tP – Ticket Printer
Tare
• LP-50 – Label Printer
to select
• EPM – EPM205 Printer
NOTE: EPM will only be available for selection if
automatic accumulation is set to auto.
5. Press the ZERO key
6. Press the TARE key
press the MODE key
BAUD RATE
during
Baud rate is the RS232 transmission speed. If using a
printer, both the printer and the scale must be set to the
same baud rate. At startup, the baud rate is set at 9,600.
Enter this menu to change the baud rate setting.
1. Turn on the scale and press the TARE key
the self-test.
PO CAL
2. Press the TARE key
display.
3. Press the ZERO key
4. Press the TARE key
• EPM
• b 1200
• b 2400
• b 4800
• b 9600
5. Press the ZERO key
6. Press the TARE key
press the MODE key
PO CAL
will be shown on the display.
P6 Prt
Tare
until
Zero
to enter the menu.
Tare to change the setting.
Zero
to select the new setting.
Tare
to view additional menus or
to exit the setup menu.
Mode
PO CAL
will be shown on the display.
P8 bud
Tare until
Zero
to enter the menu.
Tare to change the setting.
Zero
to select the new setting.
Tare
to view additional menus or
to exit the setup menu.
Mode
Tare
during
is shown on the
Tare
during
is shown on the
0721 IH-5819