Vehicle Customization With Optional Ax-Lcd; Changing Display Backlight Color - Metra 99-3010S-LC Instrucciones De Instalación

Vehicle customization with the
optional AX-LCD
The AX-LCD allows the retention of the vehicles personalization
menu that is lost after removing the OE radio.
From the DIN harness with leads on the AX-LCD harness:
• Connect the Black wire to ground.
• Connect the Red wire to accessory power.
• Connect the Pink wire to the Pink wire of the 3010S-LC harness.
Note: This wire will have to be soldered onto the 3010S-LC.
• Tape off and disregard the Blue/Pink wire, it will not be used in
this application.
• Press and hold the "Return/ESC" button on the LCD screen for 5
seconds until "Select Interface" comes up.
• Select "Connection Type", and then press "Enter"
• Scroll up or down to "Gateway", and then press "Enter"
• Once done, press the "Return/ESC" button two times to get back
to the main menu.
Axxess interface installation 99-3010S-LC
(sold separately)
1. Press the front defrost button for 5 seconds,
2. Create your backlight color (Figure A):
Color level up
Color level down
(Figure A)
®

Changing display backlight color

Changing display backlight color
this will engage the "Configure Backlight
Color" mode. (Figure A)
Note: Backlight will blink while in this mode.
• Press and hold the "Face" button to
increase Red.
• Press the "Foot" button to decrease Red.
• Press and hold the "Face/Foot" button to
increase Green.
Red Green
7
• Press and hold the "Def/Foot" button to
decrease Green.
• Press and hold the "Fan Up" button to
increase Blue.
• Press and hold the "Fan Down" button to
decrease Blue.
3. After you have your desired color stop
pressing the button(s) and the blinking will
stop leaving your desired color. (Figure A)
Blue
Press and hold to enter
"Configure backlight color" mode