Handling and use
Charging mobile devices with the power bank
♦
Insert the microUSB plug on the charging cable
microUSB charging port on the mobile device, and insert the
USB plug into the USB port
process starts automatically.
♦
If charging does not start automatically, press the ON/OFF
button
NOTE
►
Alternatively, you can also use the original charging cable (USB
cable) provided by the respective device manufacturer.
♦
During the charging process, the current charge level of the
power bank is shown via the charge level LEDs
the section "Checking the charge level").
♦
To stop charging, disconnect the charging cable
mobile device and the power bank. The charging status LEDs
go out after about 20 seconds.
Using the power bank as a make-up mirror
The power bank has a normal mirror
fication
. There is also an optional LED light.
♦
Flip up the lid
♦
Press the ON/OFF button
LED light
♦
Close the lid
│
GB │ IE
■
28
briefly to start the charging process.
.
on or off.
.
on the power bank. The charging
and a mirror with triple magni-
for approx. 3 seconds to switch
into the
(see table in
from the
SPS 5000 A1