Personal Protective Equipment; Owner Responsibilities - Bosch rexroth 3842 559 921 Manual De Instrucciones

Installation
• Inspect the product for transport damage.
• Before installation, depressurize and de-energize the respective system part.
• Secure against being switched back on.
• Route the cables and lines protected to prevent mechanical damage and
ensure that no one can trip over them.
• Check all seals and locks for completeness and undamaged condition.
Commissioning
• To prevent condensation, allow the product to acclimatize for a few hours
before commissioning.
• Have the product approved by a specialist electrician on the basis of national
standards and requirements.
• Only start up a product that has been completely installed.
• Do not reach into moving parts.
Operation
• Check the product for malfunctions. Make sure that only authorized personnel
are
– starting or operating the system, or interfering with its normal operation.
– Operating component or part adjusters.
• Do not reach into moving parts.
Maintenance and repair
• Make sure that access to maintenance and inspection points is free
of obstacles.
• See section "Instandhaltung und Instandsetzung".
• Depressurize and de-energize the respective system part.
• Secure against being switched back on.
2.6

Personal protective equipment

• Wear suitable protective equipment like safety footwear, close-fitting clothing,
hair net.
You are responsible for suitable personal protective equipment.
All component parts of the personal protective equipment must be free
of damage.
2.7

Owner responsibilities

• Before commissioning or recommissioning, ensure CE conformity.
3 842 559 935/2019-08, MPS: Control unit, Bosch Rexroth AG
Safety instructions 9/30