Seat Adjustment Lever; Cutting Height Control; Fuses; Hydro Release Levers - Husqvarna P-ZT 60 Manual Del Operador

CONTROLS

Seat Adjustment Lever

The seat can be adjusted lengthways. The lever
is located under the right side of the seat (as
seen by the driver in the seat). When making
adjustments the lever is moved to the left.
IMPORTANT INFORMATION
be adjusted while the unit is in motion.

Cutting Height Control

The cutting height pedal lifts the deck to allow
setting the desired deck height. For transport,
push the lift pedal fully forward until the deck lift
latches in the transport (highest) position.
To set the deck cutting height, release deck height
control by pushing forward on the pedal.
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.
Seat should not

Fuses

Fuses are located on the right hand side of the
machine and are accessed by tilting the seat
forward. Fuses are flat pin fuses type as used in
automobiles. The 20 A is the primary fuse. The
7.5 A is for the mower deck coupling. The 10 A is
for accessories.

Hydro Release Levers

The levers are located on each side of the rear of
the unit below the rear engine plate. The bypass
linkage is used when manual pushing or pulling
the unit.
See Moving Machine By Hand in the Operation
section.
WARNING! Bypass linkages are located
near the muffler. To prevent burns, the engine
should be shut off and allowed to cool before
the bypass linkage levels are handled.
15