Publicidad
2
Attach one C Post to the remaining two corners
to complete the bottom of the unit.
4
Attach two A Short Beams and two B Long
Beams about halfway up the assembled C Posts.
Position the beams at the same level.
NOTE: If you will use this unit as a workbench, go
to instruction #7, otherwise continue with instruc-
tion #5.
6
Place another D Shelf on the second
set of beams (flanges down).
Insert the four remaining C Posts on the
post couplers. Tap the post ends with a
hammer or mallet to seat them properly.
Attach another set of long and short
beams into the tabs just above the post
couplers. Place a shelf on these beams.
Add sets of beams and shelves halfway
up and again at the top two tabs until
assembly is complete.
SKIP instruction #7.
7
Build the next section of a workbench-style assembly
following instructions #1, #2, #3 and #4. (Do not
add the Post Couplers). To create the flat, upper
work surface, assemble one set of long beams, short
beams and shelves at the upper end of each set of
posts. Position the units side-by-side.
5245-37: 2 of 2; Rev. 1; 08/03
C
Safco Products Company, New Hope, MN 55428
3
Place one D Shelf (flanges down) on the four beams.
BEAM
5
Insert one E Post Coupler to the end of each C Post.
POST
POST
COUPLER
POST
SHELF
D
POST
COUPLER
POST
Publicidad
