Installation; Delivery Check; Mounting Instruction; Adjusting The Links - Nederman FX2 Original Manual De Instrucciones

Table 4-1: Material specification
FX2 Original
1. PP plastic
2. Anodized aluminium
3. PP plastic
4. Rubber: EPDM rubber
5. Painted aluminium
6. Anodized aluminium
7. PP plastic
8. Spring: Stainless steel
9. Damper: PP/TPE
10. PP plastic
11. Axle: Stainless steel
5

Installation

WARNING! Risk of personal injury.
Always read section 3. Safety before installation, use, service, or troubleshooting of this
product.
5.1

Delivery check

If there are any damaged or missing parts when the product is delivered, notify the carrier
and the local Nederman representative immediately.
5.2

Mounting instruction

See figures 4, 5, 6, 7 and 8. The extractor arm can be mounted on wall, bench, floor or
ceiling. A mounting instruction comes together with the accessories wall/ceiling bracket,
hood and bench bracket.
See figure 9. The arm must always be mounted so that the adjusting knobs on the links are
on the right hand side.
If an UP-arrow is positioned near the duct connector, the arm must only be installed so that
this arrow points upwards.
See figure 10. Make sure the arm and the duct are properly connected.
See figure 13. Do not use a screw with that part of the arm.
5.3

Adjusting the links

The links are factory set for normal working position. Always check and adjust the links so
they will suit the users preference.
5.4

Damper, swivel and link functions

See figure 15.
1. PP plastic
2. Anodized aluminium with white electrophoretic depostion coating
3. PP plastic
4. Rubber: EPDM rubber
5. Painted aluminium
6. Anodized aluminium with white electrophoretic depostion coating
7. PP plastic
8. Spring: Stainless steel
9. Damper: PP/TPE
10. PP plastic
11. Axle: Stainless steel
FX Original/Chem
2
FX2 Chem
EN
17