Adjusting The Cleaning Switch-Off; Setting The Jet Angle; Maintenance And Care - Franke AQCT0029 Instrucciones De Montaje Y Uso

17. Adjusting the cleaning switch-off

You can activate the cleaning switch-off with the remote control (not part of the
scope of delivery, see Accessories,
Cleaning switch-off on the fitting
17.1 Hold your hand around 10 cm from the sensor for 3 seconds.
17.2 Between the 3rd and 5th flashing of the LED, remove your hand from the range
of the sensor.
• The LED does not flash.
17.3 After between 3 and 10 seconds, hold your hand around 10 cm from the sensor
again.
17.4 Once the LED has flashed three times, remove your hand from the range of the
sensor.
• The fitting will be switched off for 3 minutes.
• The LED flashes in a 10 second cycle.
☞
If you hold your hand around 10 cm from the sensor for at least 3 seconds, the fitting
will be reactivated before the 3 minutes has expired.

18. Setting the jet angle

18.1 Use a face spanner to loosen the retaining ring.
18.2 Set the desired shower range.
18.3 Use a face spanner to fasten the retaining ring.

19. Maintenance and care

The fitting must be checked and maintained at regular intervals depending on the
water quality and in accordance with the local conditions, and rules and regulations
applicable at the site.
Maintain the following components:
• Filters (see
Use suitable cleaning agents which are not harmful to the fitting in a proper manner
and rinse with water after use. High-pressure cleaners must not be used for
cleaning.
10
chapter 21.)
chapter 24) or directly on the fitting.