Lubrication; Topping Up The Oil; Connecting To A Compressed Air Source; Operation - Parkside PDAP 75 A1 Traducción Del Manual De Instrucciones Original

Lubrication

NOTE
► Regular lubrication is particularly important
to avoid friction and corrosion damage.
We recommend using a suitable special oil
for compressed air appliances (e.g. Liqui
Moly compressor oil).
–
Lubrication with mist oiler
A mist oiler (not supplied) continuously
and optimally lubricates the grinder as
a preparation stage after the pressure
reducer. A mist oiler gives off fine drops
of oil into the air flow and thus guaran-
tees a regular lubrication.
–
Manual lubrication
If you do not have a mist oiler, lubricate
the appliance before every use or longer
work sessions. Add 3–4 drops of pneu-
matic oil into the connector nipple

Topping up the oil

To ensure that the compressed air polisher remains
operational for as long as possible, make sure that
there is sufficient pneumatic oil in the appliance.
The following options are available:
♦ Attach a maintenance unit with an oiler to the
compressor.
♦ Install a fitted oiler into the compressed air line
or the compressor.
♦ Add 3–5 drops of pneumatic oil into the con-
nector nipple every 15 minutes of operation.
│ GB │ IE
■ 20
Connecting to a compressed air
source
NOTE
► Before connecting the compressed air source,
–
the correct working pressure (3–6 bar)
must be fully reached
–
make sure that the trigger is in the upper
position
♦ Attach the appliance to a compressor by con-
necting the connector nipple
hose of the compressed air source.
♦ The compressed air source must be equipped
with a pressure reducer so that you can regu-
late the air pressure.

Operation

Switching on and off
.
Switching on:
♦ Press the trigger
Switching off:
♦ Release the trigger
♦ When you have finished working, disconnect
the appliance from the compressed air source.

Polishing

♦ Add a little polish to the fitted polishing attach-
ment ,
–
Polishing hood
–
Polishing hood
–
Fake fur attachment
♦ Manually spread the polish of the surface you
want to polish.
♦ Switch on the compressed air source and allow
it to run until the maximum tank pressure has
been reached.
with the supply
to turn the appliance on.
.
and the workpiece.
(orange) for pre-polishing
(black) for final polishing
for high-gloss polishing
PDAP 75 A1