Maintenance And Cleaning - Parkside PDAP 75 A1 Traducción Del Manual De Instrucciones Original

♦ Use the pressure reducer on the compressed
air source to set the optimum working pressure.
Note that the maximum working pressure may
not be exceeded. An excessive working pres-
sure does not mean increased output; it merely
increases the air consumption and accelerates
appliance wear. Always comply with the techni-
cal information.
NOTE
► Do not apply the polish too often to the same
surface as the particles it contains could dam-
age the finish.
► Mask any plastic components beforehand as
these could be brightened by the polish.
♦ Switch the compressed air polisher on.
♦ Guide the compressed air polisher parallel onto
the workpiece.
♦ Move the appliance parallel to and evenly over
the surface being polished.
♦ Do not press down on the compressed air
polisher. Pressing down hard does not increase
the working efficiency!
♦ When you are satisfied with the result, release
the trigger to switch off the appliance.
♦ When you have finished working, disconnect
the appliance from the compressed air source.
CAUTION!
► Depending on the size and nature of the
workpiece, suitable safety precautions must
be taken. Use suitable clamps to prevent the
workpiece from slipping.
► In the event of an interruption to the air sup-
ply, release the trigger
PDAP 75 A1
immediately.

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may (due to working pro-
cesses) have accumulated on the appliance.
Avoid all skin contact with these substances.
If the skin comes into contact with hazardous
dusts, this can lead to severe dermatitis. If
dust is produced or swirled up during mainte-
nance, it can be inhaled.
NOTE
To ensure correct functioning and long-term
durability of the compressed air polisher, pay
attention to the following points:
■ Sufficient and continuously intact oil lubrication
is highly important for optimum functioning.
■ Check the speed and vibration levels after each
use.
■ Check the idle speed regularly and after any
maintenance is performed:
use a rev counter and perform the measure-
ment without any clamped tools. At a residual
pressure of 6.3 bar, the idle speed may not be
exceeded under any circumstances.
■ If the appliance is exhibiting excessive vibration
levels, the cause of the vibrations must be identi-
fied and repaired.
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at risk. In doubt, contact the
Service Centre.
■ Check the polishing disc
age.
■ Clean the appliance with a soft, dry cloth only.
■ Never use sharp or abrasive cleaning agents
under any circumstances.
regularly for dam-
GB │ IE │
21 ■