Publicidad
Idiomas disponibles
Idiomas disponibles
2. Mounting the bike
A.
First clean the outside of your vehicle. This will avoid scratching the rack and
your vehicle's finish.
B.
Install the bike carrier on the trunk by correctly placing upper and lower foot
on structurally sound place
vehicle's bodywork. Make sure that the bottom (2) and top (1) feet
are firmly against your vehicle. If your vehicle has a hatchback, the
bottom foot (2) must be firmly against the bodywork and the top
foot (1) must be positioned against the rear window. If your vehicle
has a boot, the bottom foot (2) and the top foot (3) must be firmly
against the boot.
C.
Place attach the hooks on the two top straps (3) to the top edge of
the boot or hatchback*. Adjust the straps (3) before placing the bike
rack.
D.
Adjust the arm (4) to an angle of 10 to 30 degrees
above the horizontal.Insert the security pin through
the hubs and the arm properly
E.
Fasten the bottom straps (6) to the bottom edge of the boot or
hatchback.
F.
Fasten the side straps (5) in a correct position* on the side of the
boot, hatchback. While installing the bike rack, repeatedly check
that the rack is correctly centred on the rear of your vehicle and
that the straps are symmetrical.
If necessary, cut enclosed rubber into the length wider than hook
inser the rubber to door edge; then put the hook on. Make sure the
strap is retightened after bikes mounted.
rack
on your vehicle
so that the bikes are as far as possible from your
15
Publicidad
