Leica RANGEMASTER 2800.COM Manual De Instrucciones página 31

FOR US ONLY:
FCC Note:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION:
To assure continued compliance, follow the attached
installation instructions and use only shielded interface cables
with ferrite core when connecting to computer or peripheral
devices. Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate this equipment.
Declaration of Conformity
Trade Name: Leica
Model No.: 8042
Responsible party/Support
contact: Leica Camera Inc.
1 Pearl Court, Unit A
Allendale, New Jersey 07401
Tel.: +1 201 995 0051
Fax: +1 201 995 1684
technicalinfo@leicacamerausa.com
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
Contains FCC ID: T7V1740
This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment and meets the FCC radio
frequency (RF) Exposure Guidelines.
This equipment has very low levels of RF energy that are deemed
to comply without testing of specific absorption ratio (SAR).
This product is in conformity with performance standards for
laser products under 21 CFR 1040, except with respect to
those characteristics authorized by Variance Number
FDA-2016-V-3483 effective November 4, 2016
Type No.: 8042
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
EN
31