Kohler K-13680 Manual Del Usuario página 9

Eye
Subassembly
5. Connect the Electrical
Locate the eye sub-assembly. Locate the wire connector on the eye
sub-assembly. Locate the wire connector coming from valve
supply assembly. Connect the wire from the valve supply
assembly to the wire from the eye sub-assembly.
Install an insulated bushing in the box to protect the power
supply lead from damage. Connect the power supply lead to the
externally mounted power supply using the supplied extension
cord. Refer to the power supply installation instructions for final
connection.
Tighten all connections. Open the stop valve by turning the
handle parallel to the piping. Test the assembly with water and
power ON. Cover the lens for at least 30 seconds. Uncover the
lens. The valve should flush after a slight delay. Ensure there are
no leaks before completing assembly.
Kohler Co.
Wire
Connection
from Valve
Assembly
9 111769-2-AB