Back-Up Batteries - Technoline WS6830 Manual De Instrucciones

Insert the holder to the bottom of the outdoor transmitter for table standing or insert it to the back of
the transmitter for wall mounting purpose.
During reception of the DCF time signal, your thermometer does not take temperature measurement.
It will change to low brightness and will resume to high brightness after auto reception. After first time
installation, the temperature readings will get stable and become more accurate in around 30 minutes.

BACK-UP BATTERIES

When the power supply is not in use, the station will be powered by the back-up batteries. The LED
display is turned off, but time and alarm time remain stored (also in the event of a power failure).
DCF SIGNAL RECEPTION AND SIGNAL INDICATOR
After the station is powered up, it starts to receive DCF signal. The
Receiving DCF signal
Successful reception
Failed reception
During reception, press the HOUR / WAVE button will display reception mode and signal strength
indication:
When strong DCF signal is detected, display shows with 3 bars
When weak or no DCF signal is detected, display shows
During reception, the signal strength may move from 1 bar to 2 bars to 3 bars. This is normal since
the clock is detecting DCF signal and other signals in the air at the same time. Press the TIME button
will return to the normal time display (if the clock does not catch DCF time signal for 21 minutes, it will
go back to normal time display).
Press and hold the HOUR / WAVE button again to stop receive the DCF.
Successful reception or failed reception
Icon becomes static on (stop blinking) when reception is successful.
Icon disappears when reception is failed.
Automatic reception and manual reception
( Icon flashing)
( Icon becomes static)
( Icon disappear)
or
EN3
icon flashes.
.
.