Samoa NEXU Manual Instalación página 12

EN
3. INSTALLATION AND CABLING
You will see there is another connector (orange colour) and the philosophy is a little bit different and it implies different wiring.
Now BUS IN and BUS OUT are only used for transferring communication and GROUP is used for transferring power and communication to the
elements which are connected to that connector. As a guidance, the wire that is connected to GROUP is the one that is marked with a red arrow.
Wiring for UDat and UDat+ is as follow.
Be aware that this is the standard way of connecting.
Please check chapter 3.4 for particular wiring.
For two-connectors UDat and UDat Power +, we can find this board:
For thee-connectors UDat and UDat Power +, we can find this board:
Be aware that this is the standard way of connecting.
Please check chapter 3.4 for particular wiring.
12
838 861 R. 06/21
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com