Symbols; And Accessories; Assembly; Accessories - Imetec PIUMA CORDLESS N4001 Manual De Instrucciones

en
DescripTion oF appliance anD accessories
refer to Figure [A] in the ILLUSTrATIvE GUIDE to check the contents of the package.
1. Handle
2. Fastening screw
3. Charging contact
4. Plug
5. Multi-surface brush
6. Suction inlet
7. Dust collection system
7A. Dust collection compartment
7B. Filter protection mesh
• Loosen the fastening screw (2) of the handle and remove it.
• Attach the handle (1) to the body of the appliance, taking care to assemble it correctly.
• Insert the fastening screw (2) and tighten it clockwise with the aid of a screwdriver [Fig.
B1].
• Attach the brush (5) to the suction connection (6) [Fig. C1].
Your appliance is equipped with the following attachments:
• MULTI-SURFACE BRUSH: suitable for all surfaces: ceramic, marble, parquet and rugs.
aTTenTion!
only use the original battery charger supplied with the appliance.
than 45°.
before using the appliance for the first time, the battery must be completely
charged.
noTe: The product must be set in a stable position while charging.
charging The baTTerY
• Make sure the appliance is set to OFF before recharging it.
• Fit the feeder (4) into the recharge contact (3) [Fig. D1].
• Connect the plug (4) to the socket.
14
Attention
ON/OFF button

ACCESSORIES

preparaTion

Do noT charge the appliance with temperatures lower than 0° and higher

SYMbOLS

7C. Filter
7D. MAX Level
8. Dust collection compartment lever
9. Technical data
10. Electronic power control
11. ON/OFF switch
12. Battery status LED
13. Battery cover
14. Battery pack

ASSEMbLY

Prohibited
Corrosive substances hazard