KNOVA KN 5025 Manual De Instrucciones página 3

SPECIFICATIONS
Model No.: KN 5025.
Square driver (inches): 1/2" (12.7 mm).
Length: 650 mm.
Max. operation ranger:
340 N-m / 250.7 ft-lg / 3009 in-lb / 3 469 kg-cm.
Accuracy: ±2% - CW / ±3% - CCW.
Bright LED: 12 LED / 4 Reds + 8 Greens.
Operation mode: Peak hold / Track.
Unit selection: N-m, ft-lb, in-lb, kg-cm.
Head type: Lever Type Ratchet.
Gear teeth: 36.
Button: 4.
PC connectivity: No.
Battery: AA x 2.
Battery life (continuous operation) *2: 110 hrs.
Battery life (standby) *2: 1 year.
Operating temperature: -10º c ~ 60º c.
Storage temperature: -20º c ~ 70º c.
Humidity: Up to 90% noncondensing.
Drop test: 1 m.
Vibration test *3: 10 G.
Life time *4: 10000 cycle.
Environmental test *5: Pass.
Electromagnetic compatibility test *6: Pass.
BEFORE USING THE WRENCH
BATTERY INSTALLATION
• Remove the battery cap.
Note:
*1: The accuracy of the readout is guaranteed from
*2: Use two AA batteries (Tested condition:
*3: Horizontal and vertical test.
*4: One cycle means turning the torque wrench
*5: Environmental test:
*6: Electromagnetic compatibility test:
• Insert two R6/AA batteries matching the -/+
• Replace the battery cover and rotate it tightly
Battery and cap
• Press
• Usually press
ATTENTION:
20% to 100% of maximum range + /- 1
increment. The torque accuracy is a typical
value. Calibration point is at the middle line of
black circle area on the rubber grip. For
maintaining accuracy, calibrate the wrench at
regular intervals (1 year recommended). And
the accuracy is based on the zero degree of
offset from perpendicular drive.
Toshiba carbon-zinc R6UG battery).
from 0 N-m to maximum range and back
to 0 N-m.
a. Dry heat
b. Cold
c. Damp heat
d. Change of temperature
e. Impact (shock)
f. Vibration
g. Drop
a. Electrostatic discharge immunity (ESD)
b. Radiation susceptibility
c. Radiation emission
polarities of the battery to the battery
compartment.
according to the following figures.
POWER ON AND RESETTING THE WRENCH
to power on the digital torque wrench.
to reset the digital torque
wrench before using it.
If an external force is applied to the torque
wrench during power-on/reset or wake up
period, an initial torque offset will exist in the
memory.