KNOVA KN 5025 Manual De Instrucciones página 4

POWER ON AND RESETTING THE WRENCH
ACTIVATION DURING SLEEP MODE
• The wrench will auto sleep after about 5
minutes idle for power saving. Press
wake up the wrench during the sleep mode.
CAUTIONS:
During communication period ( send appears),
the sleep function is disabled.
RESETTING THE WRENCH
• Press together will reset the wrench.
• If the wrench does not function normally,
press together to reset the wrench.
LOW BATTERY VOLTAGE
PROTECTION
• If the battery serial voltage is low, the wrench
will display a battery symbol and then turn off.
Replace batteries.
SETUP
STEP 1: UNIT SELECTION
Pre-setting unit: N-m
Unit selection: in-lb
Unit selection: ft-lb
Unit selection: kg-cm
to
Press
Press
Press
* Note1, 2
SETUP
STEP 2: SET TORQUE VALUE
Pre-setting torque value
Press
Increase max. torque value
Press
Decrease max. torque value
STEP 3: PEAK HOLD / TRACK MODE SELECTION
Track mode
Long press
Set peak/Track mode
Press
Set peak/Track mode
Press
Communication
Press
Peak hold mode
Note: 1. Communication is for calibra-
tion of torque wrench. Please contact
your local dealer for more information.
Note:
1. The
"Unit selection"
is cyclic.
for selection
*Note 1
Communication
(Exit)