Installation; Normative And Prescriptions; Preliminary Operations; Appliance Positioning - Lincar G3130 Manual Del Usuario

1 INSTALLATION

RESERVED TO INSTALLER

1.1 Normative and prescriptions

Read carefully the contents of this handbook, it contains important information and
•
instructions for installation, use, maintenance and product safety. This handbook must be
ridden and study in all parts, otherwise it will be consider as " Improper Use " and a not
correct employ of the Lincar equipment.
The appliance must be installed inside an environment considered suitable for
•
installation and use by competent authorities. All laws, standards and regulations in force
on the installation site must be observed, especially regarding fire prevention.
Technological connection and appliance installation must be carried out by qualify staff
•
authorized to release a conformity certificate according with the normative in force and
current standards.
All the normative concerning civil town planning and/or industrial in force must be
•
respected inside environment installation of appliance.
All laws, standards and regulations in force on the installation site must be observed,
•
regarding: gas and flues, electricity, water and steam, drains and waste disposal, forced
ventilation/extraction, air intake and air conditioning. All the local and energy supplier
authorities's prescriptions must be respected.
The installation must be carried out and certified according to the normative in force
•
regarding: work safety and accident prevention regulations, hygiene and health, fire
prevention, no-panic safety for activities open to public.
The manufacturer declines any kind of responsibility in presence of problems
•
caused by a not correct installation, use or tampering.

1.2 Preliminary operations

Before installation, check the appliance integrity. In case of doubt, do not use the
•
appliance and contact immediately the supplier.
Remove protective films and adhesive labels and eliminate all traces of adhesive with
•
petrol. Do not use aggressive solvents to clean plastic parts.

1.3 Appliance positioning

If the unit is installed against a wall, the wall needs to withstand temperatures of 80°C
•
and must be fireproof. On the contrary the unit should be positioned respecting at least a
distance of 5 cm from the wall.
The appliance should be installed and placed under an extractor hood according with the
•
normative in force.
This appliance type are not suitable to built in.
•
The air inlet vents or heat dissipation openings must be of suitable size and located
•
where they will not be obstructed, even partially.
Install the appliance horizontally, correct the positioning by turning the levelling feet.
•
12/48
mod. G10