Before The Measurement - ProMed BDP-200 Instrucciones De Empleo

OPERATING THE DEVICE
Setting the clock
Upon initial commissioning / battery change
• To switch on, press the Start/Stop button (A).
• Now press the Mode button (C). The four-digit year display flashes.
• By pressing the Set button (B), you can set the year.
• By pressing the Mode button (C) again, you enter the setting mode for the month. By
pressing the Set button (B), you can set the month.
• By pressing the Mode button (C) again, you enter the setting mode for the month. By
pressing the Set button (B), you can set the day.
• By pressing the Mode button (C) again, you enter the setting
mode for the hour. By pressing the Set button (B), you can set
the hour.
• By pressing the Mode button (C) again, you enter the setting
mode for the minute. By pressing the Set button (B), you can set
the minute.
• By pressing the Mode button (C) again, the settings are stored
and the device switches to the stand-by mode.
DE

Before the measurement

Before you carry out a blood pressure measurement you should remain
EN
entirely calm for 5 - 10 minutes, not eat, not drink any alcohol, not
smoke, not do any sport and not bathe. All of these factors influence
the measurement result. Remove items of clothing that are tight on your
upper arm. Always measure on the same arm (normally left). Carry
FR
out the measurement regularly at the same time of day, because blood
pressure changes during the day.
IT
Factors that can lead to incorrect measurements
Everything that supports the arm during measurement can increase the blood pressure. Make
ES
sure that you are in a comfortable position and do not move your arm during the measurement.
If necessary, you can place a cushion under the arm to be measured If the arm artery is lower
or higher than the heart this will lead to an incorrect measurement result.
NL
Note:
RU
Only use manufacturer-approved and clinically approved cuffs.
A loose cuff or a defective cuff with an exposed bladder leads to wrong measured values.
In the event of repeated measurements, blood is accumulated in the arm arteries which
may result in wrong measured values. Continuing blood pressure measurements should be
PL
repeated after a waiting period of at least 1 minute. It is important to hold the arm upwards in
order to ensure that the accumulated blood can drain.
TR
AR
28