Sauder Hutch 109871 Instrucciones De Montaje página 7

3
Flat
end
MOLDING
CONNECTOR (BB)
LEFT
MOLDING (N2)
Unfinished
surface
- Position the FRONT MOLDING (L2), RIGHT MOLDING (M2), and LEFT MOLDING (N2) next to each other
as shown.
NOTE: Be sure the unfinished surfaces of the MOLDINGS are facing up.
- Using your hammer, tap the MOLDING CONNECTORS (BB) down into the notches in the MOLDINGS until the
flat ends of the MOLDING CONNECTORS are even with the top surfaces of the MOLDINGS.
NOTE: Be sure to insert the MOLDING CONNECTORS rounded end first. You should be tapping on
the flat ends of the MOLDING CONNECTORS. Follow the diagram closely.
Use your hammer to
tap the MOLDING
CONNECTOR (BB)
into the notches in
the MOLDINGS.
FRONT
MOLDING (L2)
Unfinished
surface
www.sauder.com/services
Flat
end
MOLDING
CONNECTOR (BB)
Unfinished
surface
RIGHT
MOLDING (M2)
109871