Sauder Hutch 109871 Instrucciones De Montaje página 8

4
RIGHT
MOLDING (M2)
Surface with
larger holes
1- -1/2" PAN HEAD SCREW (VV)
(9 used in this step)
- Position the TOP (C) as shown.
NOTE: Be sure the unfinished edge and unfinished surface of the TOP are facing as shown.
- Fasten the FRONT MOLDING (L2), RIGHT MOLDING (M2), and LEFT MOLDING (N2) to the TOP (C) as
shown. Use five 1- -1/2" PAN HEAD SCREWS (VV) through the holes in the FRONT MOLDING. Use two 1- -1/2""
PAN HEAD SCREWS (VV) through the RIGHT and LEFT MOLDING.
NOTE: At this time, do not tighten the SCREWS in the MOLDINGS.
NOTE: Be sure the surface with larger holes of the MOLDINGS are facing up. Follow the diagram.
- Now, be sure the pointed corners of all three MOLDINGS line up with each other. Tighten the SCREWS in all the
MOLDINGS. Do not overtighten the SCREWS.
109871
FRONT
MOLDING (L2)
Surface with
larger holes
www.sauder.com/services
Unfinished
surface
Unfinished
edge
TOP (C)
LEFT
MOLDING (N2)
Surface with
larger holes