Tabla de contenido
Publicidad
Section 4 Operation
Advanced - Charting
4-54
Charting
is used to view a graphical display of your program.
Charting
XX.XX°C
+
-
XX:XX
Enable the green box to display the external temperature sensor chart.
The current external temperature sensor is also displayed in the upper left
hand corner of the display.
Enable the yellow box to display the internal temperature sensor chart.
The current internal temperature sensor is also displayed in the upper
middle of the display.
Enable the blue box to display the setpoint chart. The current setpoint is
also displayed in the upper right hand corner of the display.
The white horizontal axis on the bottom of the display represents time.
The right end of the display always shows the current time. Use the white
zoom tools to change the displayed time increments. There are eight
incremental ranges available, from one minute to two hours. Units are
minutes/division or hours/division.
The red vertical axis on the left hand side of the display represents tem-
perature. The temperature scale depends on the units selected in
Menu - Display Options - Temp. Units
to change the displayed temperature increments. There are 12 incremental
ranges available, from 0.1 of a degree to 500 degrees.
The red dash is used to horizontally center the setpoint chart on the dis-
play. If desired, use the triangles to move the desired setpoint chart up or
down the display. Use the red dash again to center it.
XX.XX°C
XX.XX°C
XX Min/Div
XX:XX
. Use the red zoom tools
+
-
Thermo Scientific
Publicidad
Tabla de contenido
