Publicidad
Idiomas disponibles
Idiomas disponibles
USB POWER PORTS
The LBXR20BT Bluetooth
equipped with a USB Type A power port (9).
It delivers 1 amp total current.
• Make sure battery is charged.
• Insert a USB plug into USB power port to
supply power or charge your device.
• Press the USB button (8) or turn the
USB on through the SMARTECH
*The Bluetooth
word mark and logos are
®
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by
BLACK+DECKER is under license. Other
trademarks and trade names are those of
their respective owners.
SAFETY WARNINGS AND
INSTRUCTIONS: DRILLS
1. Hold drill firmly with one hand on the
grip and the other hand on the bottom
of the battery pack.
2. When attaching accessories in the drill
chuck, hand tighten the keyless chuck firmly.
WARNING:
Drill may stall (if overloaded
or improperly used) causing a twist. Always
expect the stall. Grip the drill firmly with both
hands to control the twisting action and
prevent loss of control which could cause
personal injury. If a stall does occur, release
the trigger immediately and determine the
reason for the stall before restarting.
INSTALLING AND REMOVING THE
BATTERY PACK FROM THE TOOL
WARNING:
Make certain the lock-off
button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert
battery pack (6) into tool until an audible click
is heard (figure B). Make sure battery pack
is fully seated and fully latched into position.
TO REMOVE BATTERY PACK: Depress
the battery release button (7) as shown in
figure C and pull battery pack out of tool.
B
battery is
®
TM
app.
6
C
7
OPERATING INSTRUCTIONS
WARNING:
serious personal injury, turn tool off and
disconnect tool from power source before
making any adjustments or removing/
installing attachments or accessories.
TRIGGER SWITCH & REVERSING
BUTTON
•
The drill is turned ON and OFF by
pulling and releasing the trigger switch
(1). The farther the trigger is depressed,
the higher the speed of the drill.
•
A forward/reverse control button (2)
determines the direction of the tool and
also serves as a lock off button.
•
To select forward rotation, release the
trigger switch and depress the forward/
reverse control button to the left.
•
To select reverse, depress the forward/
reverse control button the opposite direction.
NOTE: The center position of the control
button locks the tool in the off position.
When changing the position of the control
button, be sure the trigger is released.
TORQUE CONTROL (FIGURE D)
This tool is fitted with a torque adjustment
collar (3) to select the operating mode and
to set the torque for tightening screws.
Large screws and hard workpiece materials
require a higher torque setting than small
screws and soft workpiece materials.
• For drilling in wood, metal and plastics,
set the collar to the drilling position
symbol
• For screwdriving, set the collar to the
desired setting. If you do not yet know the
appropriate setting, proceed as follows:
• Set the collar to the lowest torque setting.
• Tighten the first screw.
• If the clutch ratchets before the desired
result is achieved, increase the collar
setting and continue tightening the screw.
Repeat until you reach the correct setting.
Use this setting for the remaining screws.
8
To reduce the risk of
Publicidad
